PVC ceiling and wall panel production line extrusion line manufacturer
SHARC MACHINE company manufacture complete sets PVC ceiling and wall panel production line extrusion lines for more than 20 years
SHARC MACHINE company manufacture complete sets PVC ceiling and wall panel production line extrusion lines for more than 20 years
Running PVC ceiling panel machine video:
Final PVC ceiling panel pictures:
PVC ceiling wall panel is mainly made of PVC resin and calcium carbonate and additives. The main advantages of PVC ceiling panel are: light weight, easy installation, waterproof and moisture-proof, moth-proof, the surface color pattern changes a lot, and it is resistant to pollution, easy to clean, and has good performance of sound insulation and heat insulation , In particular, the flame retardant material is added to the new process, so that it can be extinguished immediately after leaving the fire, and it is safer to use. Common width of PVC ceiling and wall panel ranges from 100-603mm.
Process of PVC ceiling and wall panel production line extrusion line process:
Step 1 is raw materials mixing and feeding process:
This process mix raw materials according to formula, it can be semi-automatic and fully automatic, we can design this feeding system according to clients’ capacity and other clients factory status.
Step 2 is PVC ceiling panel extrusion process:
By this step, clients can can get all sizes PVC ceiling panels, clients can get all design panels. To get design, basically there are 3 ways: hot stamping machine, offline printing machine and lamination machine.
Step 3 is recycling process:
This step is helpful to reduce the production cost for clients, during PVC ceiling panel making process, sometimes there is waste products, if we don’t recycle them, it will occur wastage and increase clients’ production cost, therefore we need this recycling process. It mainly includes PVC crusher and PVC pulverizer.
Main models and Technical parameters of PVC ceiling and wall panel production line extrusion line:
Model | 48/51 | 53/55 | 65 | 80 |
Applicable product width(mm) | <300 | <400 | 200-603 | >200 |
Extruder | SJSZ48/113 or SJSZ51/105 | SJSZ55/110
Or SJSZ53/128 |
SJSZ65/132
Or SJSZ65/138 |
80/156 |
Capacity (m2/24hour) | 800-1200 | 1600 | 2400 | 3600 |
Components of PVC ceiling and wall panel production line extrusion line:
To set up a factory of producing PVC ceiling panel, firstly we need find out where to get raw materials. Main materials for PVC ceiling panel production are PVC resin(k value 65-67), calcium carbonate(smaller than 800mesh, normally clients use 1000mesh) and additives(PE/Paraffin wax, stearic acid, stabilizer and etc ). Basically all clients can get PVC resin and calcium carbonate in their own country. For additives, SHARC MACHINE company can help clients to get.
Components of PVC ceiling and wall panel production line extrusion line:
Main Features of PVC ceiling and wall panel production line extrusion line:
1. Extruder adopts PVC ceiling panel dedicated screw, make sure best plasticizing effect, further make sure best final product shape
2. Extruder speed and haul off speed of my PVC ceiling panel machine controlled by ABB frequency inverter, it saves power and makes speed adjustment easy.
3. Extruder temperature of my PVC panel machine adopts PID control, temperature fluctuation self adjusting, it realize the high automatic level
4. The amount of filled calcium can be from 50phr to 250phr,easy to control product cost and quality.
5. My PVC panel making machine is equipped with infrared tracking device which can eliminate the problem of fluctuation of extrusion flow rate, further can make sure get best product
6. Lower power consumption, it can save 25-30% electricity power consumption comparing with most same kind PVC ceiling wall panel machine.
2022 © All rights reserved | Sitemap